User Manual

64
Users Manual of XGS-6350-24X4C
seconds.
owner string is used to describe some information
about the history item.
4. exit Enter the global office mode again.
5. exit Enter the management mode again.
6. write Save the configuration.
After a rMon history item is added, the device will obtain statistics values from the specified port every second
seconds. The statistics value will be added to the history item as a piece of information. If you run rmon
collection history index many times to configure history items with the same index, only the last
configuration is effective. You can run no rmon history index to cancel history items whose indexes are
index.
Too much system sources will be occupied in the case the value of bucket-number
is too big or the value of interval second is too small.
e) Displaying rMon configuration of switch
Run show to display the rMon configuration of the switch.
Command Purpose
show rmon [alarm] [event]
[statistics] [history]
Displays the rmon configuration information.
alarm means to display the configuration of
the alarm item.
event means to show the configuration of the
event item and to show the items that are
generated by the occurance of events and are
contained in the log table.
statistics means to display the configuration of
the statistics item and statistics values that the
device collects from the port.
history means to display the configuration of
the history item and statistics values that the
device collects in the latest specified intervals
from the port.
4.3.3 Configuring PDP
4.3.3.1 Introduction
PDP is a two-layer protocol specially used to detect network devices. PDP is used in Network Management
Service (NMS) to detect all neighboring devices of a already known device. Using PDP enable you to learn
the SNMP angent address and the types of neighboring devices. After neighboring devices are detected
through PDP, the NMS can require neighboring devices through SNMP to obtain the network topology.