User Manual

70
Users Manual of XGS-6350-24X4C
 Setting the acknowledgement time-delay
 Setting the maximum numbers of acknowledgement
 Showing LLC2 link information
 Debugging LLC2 link information
LLC2 Configuration Tast
5.2
5.2.1 Configuring Idle Time Value
The command is used for controlling the frequency of query at the idle time (no data exchanged)
The command “no” can be used for restoring to the default value.
Command Purpose
[no] llc2 idle-time [seconds]
Used for controlling the frequency of query at the idle
time (no data exchanged). seconds: The interval
seconds of sending RR frame at the idle time. The
maximum is 60 seconds, the minimum is 1 second, and
the default is 10 seconds.
Configuration mode: Interface Configuration
At idle time, no I (information) frame is exchanged and RR (receive ready) frame is
sent to the remote end periodically to tell the remote end that the local end is ready
to receive data. The relative small value should be set for ensuring the prompt
advice to the remote end. If the value is set too small, too many RR frames is likely
to be sent on the network.
Example: Setting RR frame sent every 12 seconds
int ethernet1/1
llc2 idle-time 12
5.2.2 Configuring the Time Value of Waiting for Acknowledgement
Command Purpose
[no] llc2 t1-time [seconds]
Used for controlling the waiting time of
expecting remote acknowledgement. The
command “no” can be used for restoring to the
default value.Seconds The seconds of
waiting for remote acknowledgement. The
maximum is 60 seconds, the minimum is 1
second and the default is 1 second.