User Manual

75
Users Manual of XGS-6350-24X4C
clearing the network timeout perceived by the opposite end. The command below can be used for setting the
value.
Command Purpose
llc2 ack-maxnumber
Setting the acknowledgement time-delay.
5.2.11 Showing LLC2 Link Information
Command Purpose
show llc interface [type number]
Used for showing the related information of
LLC2 link connection.
Configuration Mode: Interface, configuration and global
Showing the related information of LLC2 link connection. Under interface mode, the
command “show llc” is used for displaying LLC2 link information of the interface.
Example: Under interface mode, the command “show llc” is used for showing llc2 information on ethernet1/1.
int ethernet 1/1
sho llc ethernet 1/1
5.2.12 Debugging LLC2 Link Information
The command is
Command Purpose
debug llc2 [packet|error|state]
Used for opening LLC2 debug switch.
Configuration mode: Management Mode
Packet, Opening the debug switch of LLC2 link status information
Example, opening the debug switch of LLC2 link.
debug llc2 packet
debug llc2 state
debug llc2 error
5.2.13 Example of LLC2 Configuration
The number of LLC2 frame received before the response can be configured. For example, it is supposed that
two information frames are received at the time 0 rather than at the maximum number 3, the responses of
these frames are not sent. If the third frame that makes the router response is not received within 800 ms, the