User Manual

39-5
Commands
Explanation
Global Mode
[no] router IPv6 ospf <tag>
The command initializes OSPFv3 routing
process and enter OSPFv3 mode to
configure OSPFv3 routing process. The [no]
router IPv6 ospf <tag> command stops
relative process. (required)
OSPFv3 Protocol Configure Mode
router-id <router_id>
no router-id
Configure router for OSPFv3 process. The
no router-id command returns ID to
0.0.0.0 .(required)
[no] passive-interface<ifname>
Configure an interface receiving without
sending. The [no]
passive-interface<ifname>command
cancels configuration.
Interface Configuration Mode
[no] IPv6 router ospf {area <area-id>
[instance-id <instance-id> | tag <tag>
[instance-id <instance-id>]] | tag <tag>
area <area-id> [instance-id
<instance-id>]}
Implement OSPFv3 routing on the interface.
The [no] IPv6 router ospf {area <area-id>
[instance-id <instance-id> | tag <tag>
[instance-id <instance-id>]] | tag <tag>
area <area-id> [instance-id
<instance-id>]} command cancels
configuration.
2. Configure OSPFv3 parameters
（1）Configure OSPFv3 packet sending mechanism parameters
1）Set the OSPF interface to receive only
2）Configure the cost for sending packets from the interface
Commands
Explanation
Interface Configuration Mode
IPv6 ospf cost <cost> [instance-id
<id>]
no IPv6 ospf cost [instance-id <id>]
Appoint interface to implement required cost of
OSPFv3 protocol. The no IPv6 OSPF cost
[instance-id <id>] restores the default setting.