- Planet Internet Broadband Router User's Manual

Introduction

3. Connect WAN Cable

Connect the DSL or Cable modem to the WAN port on the Broadband Router. Use

the cable supplied with your DSL/Cable modem. If no cable was supplied, use a

standard cable.

4. Connect Printer Cable

Use a standard USB printer cable to connect your printer to the USB Printer port

on the Broadband Router.

NOTE: GDI printers are not supported. Please refer to the CD for a list of GDI

printers. You can also check with the printer manufacturer.

5. Power Up

• Power on the Cable or DSL modem.

• Connect the supplied power adapter to the Broadband Router and power up.

Use only the power adapter provided. Using a different one may cause hardware

damage

6. Check the LEDs

• The PWR LED should be ON.

• The STATUS LED should flash, then turn Off. If it stays on, there is a hardware

error.

• For each LAN (PC) connection, the LAN LNK/ACT LED should be ON (provided

the PC is also ON.)

• The WAN LED should be ON.

• The USB LED should be ON.

For more information, refer to Front-mounted LEDs in Chapter 1.