User Manual

- 9 -
- 10 -
- 11 -
- 12 - - 13 - - 14 -
5. Logon to the Console
(PoE Switch / FGSW-2624SF)
Once the terminal has connected to the device, power on
the FGSW-2620PVM, the terminal will display that it is
running testing procedures.
Then, the following message asks the login user name and
password. The factory default password as following and the
login screen in Figure 5-1 appears.
User name: admin
Password: admin
6. While IP Address be changed or
forgotten admin password –
To reset the IP address to the default IP Address
“192.168.0.100” and the user name / password to factory
default mode (default user name and password are both
admin). Press the hardware reset button at the front
panel about 10 seconds. After the device is rebooted, you
can login the management Web interface within the same
subnet of 192.168.0.xx and default user name/ password.
Be noted, all the previous setup will disappeared after
factory reset.
IP Address:
192.168.0.x
IP Address:
192.168.0.100
Serial Port
57600,8,n,1
FGSW Managed Switch
RJ-45/UTP-Cable
PC / Workstation
with
Web Browser
Serial Port
FGSW-2620PVM Managed Switch
PC / Workstation
with
Terminal emulation software
RS-232
▲
Hardware Reset
Figure 5-1 FGSW-2620PVM Console Login Screen
Note
1. For security reason, please change and
memorize the new password after this first
setup.
2. Only accept command in lowercase letter
under console interface.
7. Customer Support
Thank you for purchase PLANET products. You can browse
our online FAQ resource at the PLANET Web site rst to
check if it could solve you issue. If you need more support
information, please contact PLANET switch support team.
PLANET online FAQ :
http://www.planet.com.tw/en/support/faq.php?type=1
Switch support team mail address :
[e-mail]
Copyright © PLANET Technology Corp. 2010.
Contents subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology
Corp. All other trademarks belong to their respective owners.