Table of Contents REQUIREMENTS 1 PHYSICAL INSTALLATION 2 ICA-500 2 ICA-300 / ICA-302 2 IVS-100 3 CAMERA ADMINISTRATION 4 FURTHER CONFIGURATION 6
This page is intentionally left blank
Requirements ICA-500 ICA-300 IVS-100 ICA-302 Network Environment LAN 10/ 100Base-TX Ethernet Monitoring System Recommended System Hardware • CPU: Pentium III, 800 MHz or above • Memory Size: 128 MB (256 MB recommended) • VGA card resolution: 1024 x 768 or above System Requirement for software application Support OS Win 98 SE, Win 2000, Win Me, Win XP System Hardware 1-4 cameras surveillance application • CPU: Pentium III, 800 MHz or above • Memory Size: 128 MB (256 MB recommended) • VGA card reso
Physical Installation ICA-500 1. Connect an Ethernet cable Connect one end of an Ethernet cable to the LAN port located on the ICA-500 rear panel and attach the other end to the network device (hub or switch). 2. Attach the external power supply Connect the provided power adapter to the ICA-500’s connector labeled “12VDC” on rear panel. 3. Check the LEDs The STATUS would be ON, and the 10/100 LED would flash for few times to detect network connection.
Rear panel of ICA-302 IVS-100 1. Connect an Ethernet cable Connect one end of an Ethernet cable to the LAN port located on the ICA-500 rear panel and attach the other end to the network device (hub or switch). 2. Attach the external power supply Connect the provided power adapter to the ICA-500’s connector labeled “12VDC” on rear panel. 3. Check the LEDs The STATUS would be ON, and the 10/100 LED would flash for few times to detect network connection.
Camera administration PLANET Internet Cameras provide GUI (Web based, Graphical User Interface) for machine management and maintenance. When you installed your IP camera over your network environment, To start web configuration, you must have one of these web browsers installed on computer for web management • Microsoft Internet Explorer 6.0 or higher with Java support Default LAN interface IP address of ICA-500 / ICA-300 / ICA-302 / IVS-100 is 192.168.0.20.
Or you may execute IPEditV3 to discover IP camera’s IP address. Before starting installation, please refer to below: Procedures of IPEdit utility • Please find the IPEditV3.exe in the Utility folder on user’s manual CD • Double-click the IPEditV3.exe and the following screen should be prompt on your computer. IPEdit overview • Choose the destination camera for IP address and device name modifications or using default setting for viewing.
This page is intentionally left blank 6
