User Manual

34
6. LAN
On the LAN Settings page, you can set up LAN IP address; moreover, you can enable DHCP
Server function to assign IP addresses to users on the LAN.
DHCP stands for Dynamic Host Control Protocol. MZK-W04NU Wireless Router has a built-in
DHCP server which can automatically assign an IP address to those computers/devices on the
LAN/private network. If you enable DHCP server, the client device will obtain an IP address
automatically. Whenever you turn on the computer, the client device will automatically load the
proper TCP/IP settings from MZK-W04NU. The DHCP server will allocate an unused IP address from
the IP address pool to the requesting computer, but you must specify the beginning and ending
address of the IP address pool.
LAN IP
 IP address：Here is the IP address of the LAN side of MZK-W04NU. It is usually the default
gateway of the client’s PC. The default IP address is “192.168.1.1”.
 Subnet Mask：The Subnet Mask of the LAN side of MZK-W04NU is “255.255.255.0”.
DHCP Server
 DHCP Server：Click to “Enabled” the DHCP server of MZK-W04NU.
 Start Address/End Address：Please enter the first and the last IP addresses which
MZK-W04NU distribute IP addresses to. The IP addresses in this range can get assigned IP
addresses from MZK-W04NU. (However, all the PCs on the same LAN should use the same
subnet mask.)
 Apply：Click this button to save the settings.
 Clear：If there is anything wrong with the settings you made, you can click “Clear” to
configure the page again.