User Manual
39
7.4. PPPoE Unnumbered
Unnumbered PPPoE can let you manage a range of IP addresses but only need to dial once. When
an IP address is received at the gateway, the driver will use network mask to configure the subnet
mask of ASIC. At the server side, you must delete the corresponding hot route and add a new
network route so that the packets can be correctly routed to gateway.
USER ID：Enter the User Name provided by your ISP. (The ID must be alphanumeric
characters and case sensitive.)
Password：Enter the Password provided by your ISP. (The password must be alphanumeric
characters and case sensitive.)
Confirm Password：Enter the Password again for verification.
IP Address：Please enter the IP address provided by your ISP.
Subnet Mask：Please enter the subnet mask address provided by the ISP.
MTU：MTU means Maximum Transmission Unit, the largest physical packet size,
measured in bytes, that a network can transmit. The default value is 1454. Please set up the
MTU according to your system environment. Only enter a new MTU when your ISP requires,
otherwise, please leave it as the default setting. When using PPPoE connection, you may
need to change MTU settings to maintain the connection with your ISP, however, if the
incorrect value was entered, you may be unable to access certain websites. Reducing the
packet size can help connecting to certain websites or speeding up the transmission rate.
Dial-On-Demand/Silent Timeout：You may disconnect the connection when there is no
activity for a period of time and set the Silent Timeout in the next field. Silent Timeout means
a period of idle time before you go offline. Enter a maximum period of time (minute) to
define the maximum idle time. If the silent time is above the defined maximum idle time, it
will go offline immediately. You can set the value to be 0 or Auto Reconnect to disable this
function.
Auto Reconnect/Connect/Disconnect：If you choose Auto Reconnect, MZK-W04NU
Wireless Router will automatically reconnect to your ISP when you restart the system or the