User Manual

42
need to change MTU settings to maintain the connection with your ISP, however, if the
incorrect value was entered, you may be unable to access certain websites. Reducing the
packet size can help connecting to certain websites or speeding up the transmission rate.
 Dial-On-Demand/Silent Timeout：You may disconnect the connection when there is no
activity for a period of time and set the Silent Timeout in the next field. Silent Timeout means
a period of idle time before you go offline. Enter a maximum period of time (minute) to
define the maximum idle time. If the silent time is above the defined maximum idle time, it
will go offline immediately. You can set the value to be 0 or Auto Reconnect to disable this
function.
 Auto Reconnect/Connect/Disconnect：If you choose Auto Reconnect, MZK-W04NU
Wireless Router will automatically reconnect to your ISP when you restart the system or the
connection is stopped. To enable “Auto Reconnect” you must set “Silent Timeout” to be
0 or leave the field blank; otherwise there might be a warning message. Click “Connect” to
manually make a connection or click “Disconnect” to disconnect the connection.
 Auth Type：You may choose PAP or CHAP authentication to enhance the security of data
transmission.
 PAP –Short for Password Authentication Protocol, the most basic form of
authentication, in which a user's name and password are transmitted over a network
and compared to a table of name-password pairs. Typically, the passwords stored in the
table are encrypted. The Basic Authentication feature built into the HTTP protocol uses
PAP. The main weakness of PAP is that both the username and password are
transmitted "in the clear" -- that is, in an unencrypted form.
 CHAP –Short for Challenge Handshake Authentication Protocol, a type of
authentication in which the authentication agent (typically a network server) sends the
client program a random value that is used only once and an ID value. Both the sender
and peer share a predefined secret.
 Network 1~4：When using NAPT LAN type, you may do the following settings.
 Disable: Choose this to disable the function.
 IP Address：Please enter the range of IP addresses provided by your ISP.
 Domain Name：You can set a domain name as the transmission rule. For example,
entering “planex.com.tw” in this column, it means the packets which use
planex.com.tw as destination will be delivered through this segment.
 Apply：Click this button to save the settings.
 Clear：If there is anything wrong with the settings you made, you can click “Clear” to
configure the page again.
 Refresh：Click this button to update to the latest status.