User Manual

60
3.3. MAC Filtering
If you set MAC Filtering, only those whose wireless MAC addresses listed on the Device List can or
cannot connect with MZK-W04NU. The default mode is that all the wireless stations are allowed to
access MZK-W04NU. Up to 20 MAC addresses can be assigned by using this function.
 Action：Choose an action from the list. The default value is Disable.
 Disable – Choose this function to disable MAC filtering function. This means all the
users may connect with MZK-04G without limitation.
 Allow – Choose this function to let users only whose MAC addresses were added to
the Device List can connect with MZK-04G and eliminate other users.
 Deny –Choose this function to deny those users whose MAC addresses were added to
the Device List cannot connect with MZK-04G, while other users can connect with it.
 Apply：Click this button to save the settings and restart the router.
 Clear：If there is anything wrong with the settings you made, you can click “Clear” to
configure the page again.
 Comment：Enter any text to describe the MAC address which you want to allow or deny.
It can be 16 alphanumerical characters at most.
 MAC address：Enter the MAC address of your wireless devices here.
 Apply：Click “Apply” button to add the save/apply the settings and then the added MAC
address will be listed on the table.
 Clear：If there is anything wrong with the settings you just entered, you can click “Clear”
to configure the column again.