User Manual

61
3.4. WDS
Wireless Distribution System uses wireless media to communicate with other APs, like the
Ethernet does. To do this, you must set these APs in the same channel and set MAC address of
other APs which you want to communicate with in the table and then enable the WDS.
 WDS：MZK-W04NU supports the following mode for WDS settings.
 Disable: Disable WDS function.
 Root: In this mode, MZK-W04NU becomes the only connection between the wireless
LAN and Ethernet/Internet.
 Bridge：Connect MZK-W04NU with another wireless router, to expand the range of
the network.
 Repeater：Connect MZK-W04NU with up to four other wireless routers, to expand the
scope of network.
 MAC address：Enter the MAC address of the wireless AP here.
 Apply：Click “Apply” button to add the save/apply the settings and then the added MAC
address will be listed on the table.
 Clear：If there is anything wrong with the settings you just entered, you can click “Clear”
to configure the column again.