Operation Manual

The first time you power on your earbuds, the pairing process begins.
1 Power on the earbuds by pressing on the center button until you hear a pairing voice prompt and
the LED on the right earbud flashes red and blue.
2 Activate Bluetooth
®
on your phone and set it to search for new devices.
• iPhone Settings > Bluetooth > On*
• Android Settings > Bluetooth > On > Scan for devices*
NOTE *Menus may vary by device.
3 Select “PLT BB GO 3 (BackBeat).”
If necessary, enter four zeros (0000) for the passcode or accept the connection.
Once successfully paired, you hear “pairing successful” and the LEDs stop flashing.
NOTE To enter pair mode after the first pairing process, start with the earbuds powered off and press
and hold the center button until you hear "pair mode."
For the best sound, a good seal with your ear canal is essential. Try on the three different sized
eartips to find which one fits you best. You may end up with a different size eartip in each ear for
the best fit.
1 Remove the eartip To remove the eartip, pull straight out with some force.
2 Replace the eartip Push the eartip onto the earbud tip until it clicks in place.
3 Try it out Put the earbuds in your ears and make sure the stabilizing loop is tucked securely in your
ear for stability.
Pair and
fit
Get paired
Get the best sound
4