CS540 ™ Wireless Headset System Guide de démarrage rapide Guía de inicio rápido Guia de Início Rápido quick start guide
sistency What’s in the box Headset with pre-installed battery, eartip and earloop Base Extra eartips and earloops Headband en Telephone interface cable Power supply
Welcome to the CS540 wireless headset system. This quick start guide will show you how to set up your system and use its key features. Please refer to the separate safety instructions for important product safety information prior to installing or using the product. Bas 2 Wearing your headset When you wear the headset the microphone should rest as close to your cheek as possible without touching. • Slide the headset over and behind your ear and fit the eartip into your ear.
2 Charge the headset Place the headset in the charge cradle. The charging LED on the base will flash green when charging and turn solid green when the headset is fully charged. = 4 Configure your desk phone • Set your desk phone’s volume to mid-range. • Pick up the desk phone handset and listen for a clear dial tone. note If you do not hear a dial tone or the dial tone is not clear, look at the bottom panel of your base and slide the configuration switch to a different letter until the dial tone is clear.
2 Adjust the headset volume • Fine-tune your headset volume by pressing the volume/mute button up (increase) or down (decrease), if you wear your headset on the right. If you wear it on the left, it’s opposite: press down (increase) and up (decrease). Do not use headphones/headsets at high volumes for an extended period of time. Doing so can cause hearing loss. Always listen at moderate levels. See plantronics.com/healthandsafety for more information on headsets or hearing.
FCC Requirements Part 15 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
