Users Manual Part 1

Regulatory Compliance Information

United States/Puerto Rico

5011639

I .T. E

81242

Declaration of Conformity/FCC Regulatory Information

We Plantronics Inc, 345 Encinal Street Santa Cruz, California,

95060 USA (800) 544-4660 declare under our sole responsibility

that the products CA22CD, CA22CDSY & CA22CDDY comply with

Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on another circuit.

4. Consult the dealer or an experienced radio/TV technician for help.

Changes or modiﬁcations not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

STATEMENT FOR: Energy efﬁciency – EuP framework Directive 2005/32/EC and implementing

measure 1275/2008 incorporating commission regulation 801/2013:

Once the headset battery is fully charged the product enters a networked standby mode. The period

of time taken to enter this mode depends on how long the battery takes to fully charge. In networked

standby mode the product consumes X.X Watts. The wireless network port(s) of this product are

designed to be always active.

Mexico Singapore

Complies with

IMDA Standards

DA101619

are trademarks of Plantronics, Inc. All other trademarks are the property of their respective

owners. Manufactured by Plantronics, Inc.

215543-17 10.20

PAGE 1
STATEMENT FOR: Energy efficiency – EuP framework Directive 2005/32/EC and implementing measure 1275/2008 incorporating commission regulation 801/2013: Once the headset battery is fully charged the product enters a networked standby mode. The period of time taken to enter this mode depends on how long the battery takes to fully charge. In networked standby mode the product consumes X.X Watts. The wireless network port(s) of this product are designed to be always active.
PAGE 2
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Exposure to RF Radiation The internal wireless radio operates within the guidelines found in radio frequency safety standards and recommendations, which reflect the consensus of the scientific community. Independent studies have shown that the internal wireless radio is safe for use by consumers. Visit plantronics.com for more information.