User's Manual

ManualsBrandsPlantronics ManualsAudio EquipmentWireless Microphone Clip

PA50 Wireless Mic

Getting Started

Refer to the safety instructions at the end of this guide prior to installation or use. For the full

User Guide, visit www.plantronics.com/calisto800

The PA50 wireless mic is designed for use with the Calisto 800 series of multi-device

speakerphones. The wireless mic provides unparalleled freedom of movement and optimal

voice transmission.

1: Setup

/!\ Disconnect all cables from the Calisto base.

Insert wireless mic docking station firmly into the slots at the

bottom of the base.

Reconnect all cables. Place the wireless mic in the docking

station and charge it it for a minimum of 2 hours or until the

Calisto screen indicates the mic is fully charged.

2: Pairing

Once the wireless mic is fully charged, on the Calisto

speakerphone, go in Menu > Settings > Bluetooth Setup

and select “Headset (or Wireless Mic)” and then “Pair New

Headset”.

Put the wireless mic in pairing mode by pressing the



button for 6 seconds or until the light flashes red/green.

Press “Next” to prompt Calisto to search for it.

Follow the instructions on screen to complete pairing. Once it

is paired, the wireless mic is connected.

3: Wearing and Use

The wireless mic can be worn on a collar or lapel, see diagram

for optimal location.

The wireless mic can also be placed flat on a table for flexible

small group conferencing. It provides 360- degree microphone

coverage.

Talk Time: Up to 7 hours

Maximum range: Up to 45 feet/12 meters

Summary of content (4 pages)

PAGE 1
PA50 Wireless Mic Getting Started Refer to the safety instructions at the end of this guide prior to installation or use. For the full User Guide, visit www.plantronics.com/calisto800 The PA50 wireless mic is designed for use with the Calisto 800 series of multi-device speakerphones. The wireless mic provides unparalleled freedom of movement and optimal voice transmission. 1: Setup /!\ Disconnect all cables from the Calisto base.
PAGE 2
4: Features Once undocked, press the key on the wireless mic to replace the built-in speakerphone microphone. When the wireless mic is active, the {icon} is displayed on screen and the built-in speakerphone microphone is turned off. To transfer a call from the wireless mic to the speakerphone and back, press on the speakerphone. Talk/End button: Press with one tap to answer or end a call. The key is green when you have an incoming call, red when you are on a call.
PAGE 3
o o o o Use only the charging base supplied by Plantronics to charge the microphone. Do not use the charger for any other purpose. Charge the microphone according to the instructions supplied with the unit. Never store or use the product or charge the battery where the temperature may fall below 0°C (32°F) or rise above 40°C (104°F).
PAGE 4
FCC Requirements Part 15 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.