User Guide E N G L I S H Extra Loud Cordless Speakerphone with Caller ID F R A N Ç A I ! BOOST S BACK MUTE Clarity, a Division of Plantronics, Inc. 4289 Bonny Oaks Drive, Chattanooga, TN 37406 Tel: 800-426-3738 Fax: 800-325-8871 E-mail: claritycs@plantronics.com Website: www.clarityproducts.com ©2010 Clarity, a Division of Plantronics, Inc. All rights reserved. Clarity, Clarity Professional, XLC3.
XLC3.4 TABLE OF CONTENTS E N IMPORTANT SAFETY INSTRUCTIONS 2 G CONTENTS & PARTS CHECKLIST 5 I INSTALLATION 6 WALL MOUNTING YOUR XLC3.
XLC3.4 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the telephone. 3. Avoid contact with liquids. Do not locate base unit or handset near water, for example, near a bathtub, wash basin, sink or laundry tub, in a wet basement or near a swimming pool. 4.
XLC3.4 IMPORTANT SAFETY INSTRUCTIONS affected. If you experience hearing discomfort, you should have your hearing checked by a doctor. To protect your hearing, you should: A) Set the volume control in a low position and gradually increase the volume as needed. Before pressing the BOOST button, reduce the volume to the lowest level. Use the phone on the lowest volume setting as possible. B) Limit the amount of time you use the telephone at high volume levels. 25.
XLC3.4 INSTALLATION XLC3.4 INSTALLATION E Connect your telephone as shown on the enclosed Quick Start guide. Your telephone should arrive pre-assembled. To install it: 1. Remove base from package. 2. Hold one end of your XLC3.4’s long phone line cord tightly. The correct end to hold should already be plugged into your phone’s jack. Simultaneously pull the other end of the phone cord away from the phone, unraveling it and allowing you to plug that end of the cord into a wall telephone outlet. 3.
XLC3.4 WALL MOUNTING YOUR XLC3.4 XLC3.4 WALL MOUNTING YOUR XLC3.4 E Wall mount your telephone as shown on the enclosed Quick Start guide. (This is optional.) 1. Follow the instructions in the Installation section on page 6 to remove the base and handset from the base – steps 1, 4, 6. 2. Unplug the long phone line cord from the phone jack located on the back of your XLC3.4. Plug one end of the short phone line cord into the same jack identified by LINE on the back of your base. 3. Install the XLC3.
BASE - Quick Reference Guide XLC3.4 XLC3.4 4 FIND Press this key to locate handset. 1 Visual Ringer Lights up when phone rings; turns on when phone is in use. 2 IN USE / CHARGE Light The light turns red when the phone is charging, and it turns green when the phone is in use. 3 POWER Light Light is lit green when the power adapter is plugged in. During a power outage, the POWER light will blink green once per second.
XLC3.4 HANDSET - Quick Reference Guide HANDSET - Quick Reference Guide XLC3.4 E 7 S H 17 18 19 12 13 15 14 NECK LOOP 12 I OFF 9 L ON 8 G VOLUME 6 N 14 Intercom Press to call other handset on system. 15 RINGER ON / OFF Switch to turn handset ringer on or off. 16 NECKLOOP A 3.5 mm neckloop can be used in the Neckloop Port. (We recommend the Clarity CE30 Neckloop.) 17 Belt Clip The belt clip comes preattached.
XLC3.4 BATTERY INFORMATION XLC3.4 HANDSET The batteries in the handset must be fully charged for 10 hours before using the telephone for the first time. Battery life: Talk time is 6.5 hours, while standby is 130 hours without usage. Actual times will vary depending on the amplifier settings used. Replace batteries every two years. Battery spec (as supplied with your phone): 3xAAA NiMH rechargeable batteries,(1.2V 600mAh NiMH, 60AAAHC, GPI International Ltd.).
XLC3.4 VOLUME & TONE ADJUSTMENTS Digital Clarity PowerTM Technology With Digital Clarity Power, high frequency sounds are amplified more than low frequency sounds so words are not just louder, but clearer and easier to understand. It also provides intelligent amplification to make soft sounds audible, while keeping loud sounds bearable. BOOST On / Off The BOOST button controls the loudness of the receiver.
XLC3.4 PHONEBOOK XLC3.4 To access your phone’s stored records (Phonebook), and for further details regarding this feature, press the Phonebook button on the handset, and / or follow the instructions under PHONEBOOK (page 21). XLC3.4 SCREEN DETAILS IMPORTANT: In standby mode, the screen displays the date and time, handset number (for the first 10 seconds of inactivity), and date and time (after the first 10 seconds of inactivity).
XLC3.4 MENU - CALLER LIST New Calls 2 AM CLARITY To access your phonebook from standby, press MENU once to enter the menu, press DOWN once, press MENU again to select. In standby mode, press MENU twice. Use UP or DOWN to browse through your saved records. Press UP or DOWN to review the records in your call history (up to 40 records). For each record, the screen alternates between showing the date / time of call and phone number, and the name associated with the phone number that called you.
