SDS

Material name: Plasti Dip Spray 1 Gal Florecent Green
823 Version #: 01 Issue date: 07-07-2014
SDS US
3 / 12
Indication of immediate
medical attention and special
treatment needed
Provide general supportive measures and treat symptomatically. Thermal burns: Flush with water
immediately. While flushing, remove clothes which do not adhere to affected area. Call an
ambulance. Continue flushing during transport to hospital. Keep victim warm. Keep victim under
observation. Symptoms may be delayed.
General information
Take off all contaminated clothing immediately. IF exposed or concerned: Get medical
advice/attention. Ensure that medical personnel are aware of the material(s) involved, and take
precautions to protect themselves. Show this safety data sheet to the doctor in attendance. Wash
contaminated clothing before reuse.
5. Fire-fighting measures
Suitable extinguishing media
Water fog. Foam. Carbon dioxide (CO2). Dry chemical powder, carbon dioxide, sand or earth may
be used for small fires only.
Unsuitable extinguishing
media
Specific hazards arising from
the chemical
Special protective equipment
and precautions for firefighters
Fire-fighting
equipment/instructions
Do not use water jet as an extinguisher, as this will spread the fire.
Vapors may form explosive mixtures with air. Vapors may travel considerable distance to a source
of ignition and flash back. This product is a poor conductor of electricity and can become
electrostatically charged. If sufficient charge is accumulated, ignition of flammable mixtures can
occur. To reduce potential for static discharge, use proper bonding and grounding procedures.
This liquid may accumulate static electricity when filling properly grounded containers. Static
electricity accumulation may be significantly increased by the presence of small quantities of water
or other contaminants. Material will float and may ignite on surface of water. During fire, gases
hazardous to health may be formed.
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
In case of fire and/or explosion do not breathe fumes. Move containers from fire area if you can do
so without risk.
Specific methods
Use standard firefighting procedures and consider the hazards of other involved materials.
General fire hazards
Highly flammable liquid and vapor.
6. Accidental release measures
Personal precautions,
protective equipment and
emergency procedures
Methods and materials for
containment and cleaning up
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of
low areas. Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area).
Wear appropriate protective equipment and clothing during clean-up. Do not breathe mist or vapor.
Do not touch damaged containers or spilled material unless wearing appropriate protective
clothing. Ventilate closed spaces before entering them. Use appropriate containment to avoid
environmental contamination. Transfer by mechanical means such as vacuum truck to a salvage
tank or other suitable container for recovery or safe disposal. Local authorities should be advised if
significant spillages cannot be contained. For personal protection, see section 8 of the SDS.
Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Take
precautionary measures against static discharge. Use only non-sparking tools. Keep combustibles
(wood, paper, oil, etc.) away from spilled material. This material is classified as a water pollutant
under the Clean Water Act and should be prevented from contaminating soil or from entering
sewage and drainage systems which lead to waterways.
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Cover with plastic sheet to prevent spreading. Use a non-combustible material like
vermiculite, sand or earth to soak up the product and place into a container for later disposal.
Following product recovery, flush area with water.
Small Spills: Absorb with earth, sand or other non-combustible material and transfer to containers
for later disposal. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Environmental precautions
Avoid release to the environment. Contact local authorities in case of spillage to drain/aquatic
environment. Prevent further leakage or spillage if safe to do so. Do not contaminate water. Avoid
discharge into drains, water courses or onto the ground. Use appropriate containment to avoid
environmental contamination.