SDS

Most important
symptoms/effects, acute and
delayed
May cause drowsiness and dizziness. Headache. Nausea, vomiting. Severe eye irritation.
Symptoms may include stinging, tearing, redness, swelling, and blurred vision. Skin irritation. May
cause redness and pain. May cause an allergic skin reaction. Dermatitis. Rash. Prolonged
exposure may cause chronic effects.
Indication of immediate
medical attention and special
treatment needed
Provide general supportive measures and treat symptomatically. Keep victim warm. Keep victim
under observation. Symptoms may be delayed.
General information
IF exposed or concerned: Get medical advice/attention. If you feel unwell, seek medical advice
(show the label where possible). Ensure that medical personnel are aware of the material(s)
involved, and take precautions to protect themselves. Show this safety data sheet to the doctor in
attendance. Wash contaminated clothing before reuse.
5. Fire-fighting measures
Suitable extinguishing media
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
Unsuitable extinguishing
media
Do not use water jet as an extinguisher, as this will spread the fire.
Specific hazards arising from
the chemical
Contents under pressure. Pressurized container may explode when exposed to heat or flame.
During fire, gases hazardous to health may be formed.
Special protective equipment
and precautions for firefighters
Firefighters must use standard protective equipment including flame retardant coat, helmet with
face shield, gloves, rubber boots, and in enclosed spaces, SCBA.
Fire fighting
equipment/instructions
In case of fire: Stop leak if safe to do so. Do not move cargo or vehicle if cargo has been exposed
to heat. Move containers from fire area if you can do so without risk. Containers should be cooled
with water to prevent vapor pressure build up. For massive fire in cargo area, use unmanned hose
holder or monitor nozzles, if possible. If not, withdraw and let fire burn out.
Specific methods
Use standard firefighting procedures and consider the hazards of other involved materials. Move
containers from fire area if you can do so without risk. In the event of fire and/or explosion do not
breathe fumes.
General fire hazards
Flammable aerosol. Contents under pressure. Pressurized container may explode when exposed
to heat or flame.
6. Accidental release measures
Personal precautions,
protective equipment and
emergency procedures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of
low areas. Many gases are heavier than air and will spread along ground and collect in low or
confined areas (sewers, basements, tanks). Wear appropriate protective equipment and clothing
during clean-up. Do not breathe mist or vapor. Emergency personnel need self-contained
breathing equipment. Do not touch damaged containers or spilled material unless wearing
appropriate protective clothing. Ventilate closed spaces before entering them. Local authorities
should be advised if significant spillages cannot be contained. For personal protection, see section
8 of the SDS.
Methods and materials for
containment and cleaning up
Refer to attached safety data sheets and/or instructions for use. Eliminate all ignition sources (no
smoking, flares, sparks, or flames in immediate area). Keep combustibles (wood, paper, oil, etc.)
away from spilled material. This material is classified as a water pollutant under the Clean Water
Act and should be prevented from contaminating soil or from entering sewage and drainage
systems which lead to waterways. Stop leak if you can do so without risk. Move the cylinder to a
safe and open area if the leak is irreparable. Isolate area until gas has dispersed. Cover with
plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth and place into
containers. Following product recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination. For waste disposal, see section 13 of the SDS.
Environmental precautions
Avoid release to the environment. Prevent further leakage or spillage if safe to do so. Avoid
discharge into drains, water courses or onto the ground. Inform appropriate managerial or
supervisory personnel of all environmental releases.
3 / 13
Material name: 11oz PLASTI DIP SPRAY BLACK - WS
05242 108258 604 Version #: 03 Revision date: 07-21-2015 Issue date: 07-15-2015
SDS US