User's Manual

JB-BA-100m JayBird Bluetooth® Adapter for MP3 User Guide
Pairing the adapter with your JayBird Bluetooth® Stereo Headset
1. Remove the adapter from the Charging Dock.
2. Press the button on the adapter for a few seconds until the LED flashes.
The adapter LED will blink once every three seconds while in search
mode.
3. Make sure that your headset is turned off.
4. Put the headset into pairing mode by pressing the POWER/TALK button
on the headset until the LED on the right earpiece blink alternating red and
blue colors.
5. Once the headset finds and pairs with the adapter, both the adapter and
headset LEDs will blink blue once every six seconds. Your headset and
adapter are now paired.
Listening to Music
1. Plug the 3.5mm audio connector into the headphone jack on your MP3
player (or any stereo audio device with a 3.5mm headphone jack).
2. Confirm that your adapter is paired with your headset and that both are
turned on. The LED on the adapter and on the headset should both be
blinking blue every six seconds. If the LED is not blinking on your adapter,
turn it on by pressing the button on the adapter for a few seconds until the
LED start flashing.
3. Turn on your MP3 or other device and play music. You should now hear
the music on your headset.
4. You can change the volume level by using your UP/DOWN volume
buttons on the headset. You can also change the volume by using the
volume controls on your MP3 player. It’s a good idea to find an
acceptable volume on the MP3 player and is not a good idea to use full
volume on the MP3 player. Set the volume once on your MP3 player and
use the headset UP/DOWN volume buttons for adjusting the volume
levels.
5. Be sure to turn off the adapter after use by pressing the adapter button for
a few seconds. The LED will flash blue when turning off the power. The
LED will completely turn off when the adapter is turned off.
Using the phone call feature of your JayBird Bluetooth® Stereo Headset
1. The JayBird Bluetooth® Stereo Headset can also be paired with any
compatible Bluetooth® enabled mobile phone. For pairing instructions,
refer to the user manual that came with your headset.
2. Once paired with a mobile phone, you can make and receive phone calls
even while listening to music from your MP3 player wirelessly using your
JayBird Bluetooth® Adapter. When a call comes in, you will hear the
phone ring. Answer the call by pressing the TALK button on the headset
(or by pressing the answer button on your phone) and the music will turn