User Manual

5. Trim wire ends so all
conductors are equal
length and uniform.
6. Insert wires into the connector and pull
connector down over the cable jacket. Cable
jacket should seat snugly in rear of connector.
4. Straighten wires, separate pairs, and put in
desired order. See wiring chart on crimp tool.
2. Keeping foil intact, trim/cut foil leaving 1/2” to
5/8” of foil. Fold back over the cable jacket.
3. Pull drain wire down and away from the con-
ductors and wrap/coil tightly around the foil.
1. Strip off approximately
two inches of outer cable
jacket as shown.
SHIELDED
EZ-RJ45
®
Instructions
IS 100020 Rev. A ©Platinum Tools, Inc. 2009
www.platinumtools.com Moorpark, CA.
P/N 100044
P/N 100004
For best results use
EZ-RJ45
®
Crimp Tools
7. Double check wiring
sequence and make
sure the foil & drain are
positioned on the
grounding platform of
the connector.
9. Actuate the EZ-RJ45
®
Tool to crimp and trim
wires. Break off any
remaining loose wires.
8. Push the EZ-RJ45
®
connector into the EZ-
RJ45
®
Crimp Tool. Make
sue the connector is fully
seated in crimp cavity.
Grounding platform
Manu. By SullStar Technologies Inc. Patented: 5,996,224 & 6,017,237.
Other patents pending. Patents insured.