User Manual

24
Connect the cable from the switch to the test-
er and press the MODE button until the Link
Light icon and “Linc” is displayed on the
screen, then press “OK”.
If “Linc OFF” is displayed, press the test button (check mark),
to turn it on. To turn the Link Light off, press the test button
until Linc OFF
Continuous Loop Testing
While in a cable test mode, hold Test key for 2+ seconds to
toggle looping on/off.
Backlight and Built-in LED Flashlight
By default, the LCD backlight is turned off when the tester is
powered on.
• To turn the LCD backlight on, with the tester powered on,
press the power button again.
• To turn the backlight off, press and release the power
button.
Note that the backlight and built-in LED are synchronized to
both be turned on or off at the same time.
9
Icon/Term Description
DATA/LAN Cable Test mode
VIDEO/Coax Cable Test Mode
VOICE Cable Test Mode
TONE Mode
Port Link-Blink Mode
Passed Cable Test
Failed Cable Test
Open
There is a break in a wire between the ends
Mis-wire
The wires in a pair are not in the proper order
Short
The pairs are in contact with each other at a point in
the cable
Rev
Wires are reversed
Split
A wire in one pair is switched with the wire of anoth-
er pair
X-Over
Cross-over cable detected
ID no.
ID number for an attached remote
VOLTAGE!
Voltage higher than 60V has been detected!
UTP/STP
End-to-End Shielded Detection
Setup Menu
Audible Beep
Low Battery Indicator
Select Up/Down Keypad Buttons
“OK” Button
Setup Button
Tester Mode Button
Test Button
Power/Backlight & LED Flashlight Button