Operation Manual

9
• Setting the ash mode
1. Switch the camera ON.
2. Set the picture resolution using the mode button.
3. Press the Flash button
, the camera LCD will display a flashing
until the flash
mode is ready.
4. The Green LED light on the flash will light when sufficient battery power has
charged the flashlight between pictures.
5. Use the camera shutter button to take a picture.
Back View
Flash Button
LCD Display
• Using the test button
Press the flashlight test button located next to the Green LED to check correct operation of the flashlight.
LED
Test Button
AUTO
5 Installing your Software onto a Computer
• Window® 98SE users
Window® 98SE users will require to download DirectX 6.1 or higher software from the internet. Go to
http://www.microsoft.com/directx and find the free download DirectX 6.1.
• Install the software
IMPORTANT! - Make sure you install all the software from the CD supplied before you connect your camera to a computer and transfer pictures
from your camera to the computer.
IMPORTANT! – If the computer request you to install the Windows operating system during the software installation, place the windows CD into
the computer CD Rom drive. The computer will install the necessary les from the CD automatically. When the Windows software appears to have
nished the operation close the Windows screen. Remove the Windows CD and store safely.
1. Before you begin, close all other software applications open on your
computer.
2. Insert the CD supplied into the computer CD Rom Drive.
Open & Close
3. The CD User Interface Screen will automatically launch.
4. With the mouse, click on each software interface button in turn following the
on screen prompts.
NOTE! When prompted to do so, register your name and the other details requested for further on line support. You must be connected to your
internet service provider to register on line electronically.