User manual

BOOTH - Output to the Booth Monion system.

Impedance balanced 1/4” TRS Jack sockets.

Nominal output level 0dBu, maximum output level +23dBu.

Rear Panel Connections - Outputs

MASTER - Main mix outputs for direct connecon to the system PA.

Balanced XLR, convenonally congured for:

Pin 1 = Ground

Pin 2 = Posive Phase

Pin 3 = Negave Phase

Nominal output level 0dBu, maximum output level +28dBu.

AUX 1, 2 - Outputs to external eects units or local monitor system. These signals are also sent

to the DSUB output connector.

Impedance balanced 1/4” TRS Jack sockets.

Nominal output level -2dBu, maximum output level +23dBu.

DSUB OUT - Conforms to the TASCAM DB25 connector standard and allows mulple channels to

be sent fully balanced down a single connector for rapid connecon to external soundcards. The

DSUB Output can also be used to feed the main House PA, bypassing the master mix LEVEL

control if desired.

Balanced TASCAM DB25

Nominal output level +4dBu, maximum level +28dBu.

DSUB OUT Pinout

1 = Mix Le

2 = Mix Right

3 = Aux 1 Le

4 = Aux 1 Right

5 = Aux 2 Le

6 = Aux 2 Right

7 = Cue B Le (Post Level)

8 = Cue B Right (Post Level)

Tip!

DSUB OUT channels 7-8 can be congured as a third FX send using the Cue B phones to adjust the level, and the Cue B Cue

switches to choose the channels to send from.

H = HOT (+)

C = COLD (-)

G = GROUND