User manual
Headphone Cue system
Descripon
MODEL 1 has two independent Cue systems, A and B. Cue A routes to the right hand
side headphone monitor and the Cue B routes to the le hand headphone monitor.
The dual Cue system makes it much easier for two DJs to perform on the mixer
together as each can select a separate channel to monitor without interfering with the
other performer’s monitoring. This dual system also allows for Cue interacon
between two mixers linked together. See page 13 for details of mixer linking.
Each headphone monitor is equipped with both 1/4” and 3.5mm TRS jack sockets.
CUE A has an auto-cancel funcon, meaning that selecng one channel Cue will
automacally turn o the previous selecon.
CUE B does not auto-cancel, meaning that each channel Cue operates independently
of the other Cue switches.
SPLIT CUE/SOURCE - Split Cue works in conjuncon with the Source control. When
the Split Cue switch is up the Source Control adjusts the level balance between the
Cue and Mix Busses. When the switch is pressed down the Source control pans
between the Cue signal in the le earphone and the Mix signal in the right earphone.
Level - Sets the headphone volume level.
Warning - The headphone ampliers are capable of driving sensive headphones to
very high sound pressure levels (SPL) which could result in permanent hearing
damage!
8
Specicaon
Maximum output power
Headphone A 850mW RMS into 45 Ohms 1kHz
Headphone B 500mW RMS into 100 Ohms 1kHz
Headphone Impedance range 30 Ohms to 150 Ohms