User manual

Rear Panel Connections - Outputs
MASTER 1 - Main mix outputs for direct connecon to the system PA.
Balanced XLR, convenonally congured for:
Pin 1 = Ground
Pin 2 = Posive Phase
Pin 3 = Negave Phase
Nominal output level 0dBu, maximum output level +28dBu.
11
MASTER 2 - Secondary mix outputs for feeding a separate zone or PA.
Impedance balanced 1/4” TRS Jack sockets.
Nominal output level 0dBu, maximum output level +23dBu.
BOOTH - Output to the Booth Monion system.
Impedance balanced 1/4” TRS Jack sockets.
Nominal output level 0dBu, maximum output level +23dBu.
AUX 1, 2 - Outputs to external eects units or local monitor system. These signals are also sent
to the DSUB output connector.
Impedance balanced 1/4” TRS Jack sockets.
Nominal output level -2dBu, maximum output level +23dBu.
DSUB OUT - Conforms to the TASCAM DB25 connector standard and allows mulple channels to
be sent fully balanced down a single connector for rapid connecon to external soundcards. The
DSUB Output can also be used to feed the main House PA, bypassing the Mix 1 Level control if
desired.
Balanced TASCAM DB25
Nominal output level +4dBu, maximum level +28dBu.
DSUB OUT Pinout
1 = Mix Le
2 = Mix Right
3 = Aux 1 Le
4 = Aux 1 Right
5 = Aux 2 Le
6 = Aux 2 Right
7 = Cue B Le (Post Level)
8 = Cue B Right (Post Level)
H = Hot (+)
Tip!
DSUB OUT channels 7-8 can be congured as a third FX send using the Cue B phones to adjust the level, and the Cue B Cue
switches to choose the channels to send from.