User manual

Rear Panel Connections - Inputs

RETURN 1,2 - TRS Jack inputs for the two Return channels. These Jacks are “normalled” to the

DSUB2 IN connector, therefore if nothing is plugged into these sockets the Returns source their

signal from the DSUB system.

Input impedance = 5K Ohms

Maximum signal input level +23dBu.

RCA Inputs - These are the default inputs to all six channels. On channels 3, 4, and 5 these inputs

can be congured for use with turntables by pressing the small red buons located below each

earth binding post. Channels that are congured for turntables (phono) will show the input

selector switch illuminang red.

Input impedance = 5K Ohms

Maximum signal input level +26dBu

DSUB IN 1,2 - Conforms to the TASCAM DB25 connector standard and allows mulple channels

to be sent fully balanced down a single connector for rapid connecon to external Line Level

devices. In a xed installaon these connectors are ideal for connecng mulple CD players,

soundcard etc, leaving the RCA connectors free for guest DJs to use without disconnecng the

House system.

Balanced TASCAM DB25

Nominal input level +4dBu, maximum level +28dBu.

DSUB IN 1 Pinout

1 = Channel 1 Le

2 = Channel 1 Right

3 = Channel 2 Le

4 = Channel 2 Right

5 = Channel 3 Le

6 = Channel 3 Right

7 = Channel 4 Le

8 = Channel 4 Right

H = Hot (+)

C = Cold (-)

G = Ground

PHONO - Press this switch to congure the channel for use with vinyl turntables.

Nominal level 5 - 10mV 1kHz. Maximum input level 108mV 1kHz

Input impedance 47K Ohms. Input capacitance 250pF

DSUB IN 2 Pinout

1 = Channel 5 Le

2 = Channel 5 Right

3 = Channel 6 Le

4 = Channel 6 Right

5 = Return 1 Le

6 = Return 1 Right

7 = Return 2 Le

8 = Return 2 Right