User manual

Contour and Sculpt
Descripon
MODEL 1 provides a unique alternave to the standard type of xed frequency EQ,
which we feel oers greater creavity and the ability to perform smoother mixes.
Whereas a standard EQ has three or four controls providing cut or boost at a xed
frequency, MODEL 1 ulises a combinaon of high and low pass lters plus a wide
frequency range, swept equaliser, with asymmetric cut and boost.
CONTOUR - As the name implies these two controls allow you to “contour” the
frequency range of the audio signal. They consist of low Q, High-Pass and Low-Pass
lters designed not to add colour to the sound as they are swept across their
frequency range. Due to the low Q , these lters only cut, they do not boost, and are
shown in the posion to a give a frequency response.
The two graphs below illustrate how the frequency response is gently rolled o as
these controls are operated, and show the high degree of out-of-band aenuaon
they oer, cung the high or low frequency content of the audio signal.
SCULPT - “SCULPT” is a semi-parametric swept bell lter, and consist of two controls,
FREQ which sets the centre frequency and CUT/BOOST which adjusts the gain or
aenuaon at this frequency. The level of cut/boost is asymmetric; maximum boost
is limited to +8dB, while the cut is extended to -20dB.
Sculpt has a wide Q and a frequency range that covers almost seven octaves.
The Boost/Cut control is detented in the centre 0 posion to indicate a at frequency
response. The FREQ control isn’t detented and can be swept smoothly across its
range.
6
HPF LPF
FLAT
This graph shows the Cut/Boost response of Sculpt at Max/Min frequency