User manual

Master Section
Descripon
The Master secon includes the two Mix level controls, the Master EQ, main buss
metering, record output and the Booth monitor secon.
RECORD OUT - 3.5mm TRS Jack socket feeds the post Master EQ signal as a pre-
fader record output. Nominal level is –6dBu.
LEFT/RIGHT - Two, ten point peak reading LED meters provide visual indicaon of the
mix buss level. Although MODEL 1 has a considerable 28dB of headroom and is
unlikely to suer from clipping due to high signal levels, it is recommended to keep
the average signal level between 0 and +6. Occasional peaks to +9 is acceptable but
operaon with the PK LED ON is best avoided due to the possibility of damaging any
connected PA systems or clipping soundcards, record devices etc.
Play into the red and orange but avoid operang in the white!
MASTER 1, 2 - These controls set the output level for the two main mix outputs.
Master 1 controls the XLR outputs and Master 2 the TRS outputs.
MASTER EQ - Three-Band asymmetric EQ aects all mix outputs, including Booth and
Record. The EQ ON switch is controlled by zero-crossing detecon circuitry which
allows it to be used as a performance eect, as well as a frequency correcon tool.
The response of the Master EQ is shown below.
BOOTH - This secon controls the level and frequency response of the Booth
outputs. The Booth secon incorporates a 2-Band equaliser allowing the user to adjust
the frequency response of the Booth monitors to suit their own preference.
This graph shows the response of the Booth EQ.
7