Instructions / Assembly

58
Back Tower Roof Assembly - BRONZE
SEE PAGE 7 FOR
HOLE PATTERNS
38¹|₂"
38¹|₂"
38¹|₂"
38¹|₂"
38¹|₂"
38¹|₂"
38¹|₂"
38¹|₂"
Items for STEP 1:
(2) 2" x 4" x 38¹⁄₂" boards
(
2) 2" x 4" x 35" boards
(2) Roof Caps
(12) #14 x 1¹⁄₄" pan head screws
Items for STEP 2:
(2) Step 1 Assemblies
(4) 5/4" x 6" x 30" boards
(16) #8 x 2¹⁄₂" deck screws
Items for STEP 3:
(10) 5/4" x 6" x 30" boards
(40) #8 x 2¹⁄₂" deck screws
On a flat surface position boards together as shown.
Position roof cap flush with outside edges. Use roof
cap as a drill guide and drill ¹⁄₈" holes 1" deep. Keep
boards square while attaching roof cap to boards
with #14 x 1¹⁄₄" pan head screws.
Repeat for second assembly.
Hold assemblies 23" apart. Position boards
flush at the top and bottom as shown.
Keep boards square and secure with #8 x 2¹⁄₂"
deck screws.
Repeat for other side.
Start at the top and attach boards between top and bottom
boards as shown. Secure with #8 x 2¹⁄₂" deck screws.
Note: If the last board doesn’t fit because
the boards are oversized, remove
the bottom board and reattach.
Repeat for other side.
23"
3¹|₂"
3¹|₂"
Important do not
exceed 23"
Approximate 3¹⁄₂"
overhang each side.
5/4" x 6" x 30"
H
H
5/4" x 6" x 30"
H
H
90
˚
2
"
x
4
"
x
3
5
"
2
"
x
4
"
x
3
8
¹

₂
"
Step 1 Assemblies
SEE PAGE 7 FOR
HOLE PATTERNS
90˚
(Approximate overhang)
(Drill Hole Location)
4¹|₄"
3¹|₂"
Flip template over and
slide to 4¹|₄" placement.
H