Instructions / Assembly

79
USE THE INSTALLATION INSTRUCTIONS AND MOUNTING HARDWARE
WHICH ARE SUPPLIED WITH THE FOLLOWING COMPONENTS
SPEAK & SPY
MEGASCOPE
(PS 7838)
COMMERCIAL GRADE
TRAPEZE BAR
(PS 7538)
SPIRAL TUBE SLIDE
(PS 8820)
BRONCO RIDER
(PS 7956)
ARCH CLIMBER – Mounting Instructions
A
RCH CLIMBER (PS 8872)
WARNING: The top of the Arch Climber
must be flush with the top
of the deck surface. If the top
of the Arch Climber is above
the deck surface a tripping
hazard could exist.
1
. Place top end of the Arch Climber on top of the mount-
ing board. Using the Arch Climber as a template, mark
the mounting board through the four holes in the Arch
Climber. Drill four ¹⁄₈" holes 1" deep at the marked
locations.
2. Attach the Arch Climber temporarily to the mounting
board with four #14 x 1¹⁄₄" pan head screws provided.
3. Locate the pocket on the underside of the Arch Climber
where it meets the ground and mark ground where
anchor is to be installed. Remove Arch Climber and
screw anchor into the ground (a long screwdriver will
h
elp.) Screw the anchor deep enough so that the loop
at the top of the anchor will be in the middle of the
PlayStar logo when the Arch Climber is in the final
position.
4. Reinstall Arch Climber permanently, attaching it to
mounting board using #14 x 1¹⁄₄" pan head screws
provided.
5. Use the anchor as a drill guide and drill a ³₈" hole
completely through the Arch Climber. Attach Arch
Climber to anchor with one ³₈" x 1" hex bolt, two
³₈" washers, and one ³₈" lock nut provided.
WARNING: If soil conditions permit
anchor to be pulled out
easily, such as in sandy
soil conditions, cementing
is required.