Instructions / Assembly

33
4
"
x 4"
4
"
x 4"
4
"
x
4"
4"
x 4"
80¹⁄₂"
46³⁄₄"
46³⁄₄"
2"
x
6"
x
4
8
"
2
"
x 6
"
x 4
8
"
2" x 4" x 48" (3)
I
tems for
STEP 3:
(
2) 2" x 6" x 48" boards
(3) 2" x 4" x 48" boards
(4) ³₈" x 3" lag screws
(4) ³₈" washers
(40) #8 x 2¹⁄₂" deck screws
Items for STEP 4:
(1) Roof Assembly
(4) ³₈" x 3" lag screws
(4) ³₈" washers
(8) #8 x 2¹⁄₂" deck screws
Position boards between assemblies as shown. Keep square while securing with
#
8 x 2¹⁄₂" deck screws.
Install ³₈" x 3" lag screws with ³₈" washers at .
Position roof assembly so both sides of roof overhang 4" x 4" boards equally.
Secure each corner with two #8 x 2¹⁄₂" deck screws and one ³₈" x 3" lag screw
with ³₈" washer. (See below for detail of screw placement.)
Lift tower assembly upright and position in desired location.
Detail of Screw
Placement
Predrill –
1
/
8
" Dia. for #8 x 2
1
/
2
" deck screws
1
/
4
" Dia. for
3
/
8
" x 3" lag screws
Note: If you are using 2" x 6" lumber
for your deck boards in place of
5/4" x 6" lumber, this dimension
must be 46
¹₂ ". The reason is 2" x 6"
lumber is ¹₄" thicker than the 5/4" x 6"
lumber called for in this plan.
G
Caution: Ground must be level.
Installation on a hill or
incline will create unsafe
conditions.
PA
TTERN
B
B
B
G
G
G
G
SEE PAGES 6 & 7 FOR
HOLE PATTERNS