Instructions / Assembly

6
Patterns and can be created
anywhere along the board by turning
the template over (arrow side up)
and sliding it to the desired position.
Use the shaded holes for that pattern.
A
A
2" x 4"
2" x 4"
2" x 4"
B
B
C
D
D
PLEASE NOTE
(Letters represent pattern not position)
2" x 4"
C
Your building kit includes this template
to help you create most of the
hole patterns needed to
build your playset. Once
the template is in position,
mark only the holes that need
to be drilled for each pattern. Remove
the template before drilling.
Warning: Do not drill holes through the template
as you may damage the template.
Note: When the PlayStar logo is showing, the three
tabs on the bottom will position the template
square with any two edges. When the arrow
is showing, the two tabs on the bottom will
position the template square with one edge
only, which will allow you to slide the
template anywhere along the board.
Use an ¹₈" drill bit for all holes
unless noted (see patterns G & J)
How To Use Your Marking Template for Drill Holes:
The rigid version of the template like the one shown here
can be found inside one of the hardware boxes.
Actual Size Template
TEMPLATE FOR DRILL HOLES