Instructions / Assembly

68
21¹|₂"
16"
18"
16"
Items for STEP 7:
(5) ³₈" x 4" hex bolts
(10) ³₈" washers
(
5) lock nuts
L
ift assembly onto saw
horses as shown.
Note: If you do not have
saw horses, rest
beam on ground and
rotate A-Frame Assembly and single
4" x 4" Assembly simultaneously to
the other side (requires two adults).
Single 4" x 4" Assembly must be
supported at all times to keep the
bracket from bending. Complete
Step 7
. Rotate back to original
position and proceed with Step 8.
Use the holes in the bottom board as a drill
guide and drill ³₈" holes back through both
boards.
On the A-Frame Assembly end attach three
³₈" x 4" hex bolts, ³₈" washers and ³₈" lock nuts.
On the 4" x 4" Assembly end attach two ³₈" x 4" bolts,
³₈" washers and ³₈" lock nuts. Leave hole closest to
end open as it will be used to attach beam to tower assembly.
Note: Cut off all protruding threaded ends of
bolts with a hack saw flush to the end of the nut
and remove sharp edges with a metal file.
Mark the top board, on the bottom
edge, at the dimensions shown.
Drill a ¹⁄₄" hole 2¹⁄₂" deep in the center
of the top board at each location.
Screw swing hangers into board
by hand (a long screwdriver will help).
Tighten swing hanger until loop is tight
against adjoining board and swing hanger
is positioned as shown.
Drill another ¹⁄₄" hole 2¹⁄₂" deep
in adjoining board through
swing hanger loop and secure
each swing hanger with one
³₈" x 3" lag screw and ³₈" washer.
Items for STEP 8:
(4) swing hangers
(4) ³₈" x 3" lag screws
(4) ³₈" washers
Front View
Leave hole
open