Instructions / Assembly

69
On the 4" x 4" board of tower assembly where the Swing Station Assembly will
b
e attached, measure and mark hole location (8" down and 1³₄" from edge) as
shown.
D
rill a 1¹₈" counterbore ⁵₈" deep. Drill a ³₈" hole through the center of the
counterbore and continue through the remainder of the 4" x 4" board.
Position Swing Station Assembly against tower and secure with one ³₈" x 7"
hex bolt, washers and lock nut.
Items for STEP 9:
(1) ³₈" x 7" hex bolt
(2) ³₈" washers
(1) ³₈" lock nut
Items for STEP 10:
(2) Left-hand Sturdy-Frame
Connectors
(10) #14 x 1¹₄" pan head screws
(6) #8 x 2¹₂" deck screws
(2) ³₈" x 3" lag screws
(2) ³₈" washers
Secure the 4" x 4" board to tower with Left-hand Sturdy-Frame Connectors as
shown.
4" x
4
"
4"
x
4"
Predrill –
¹₈ " Dia. for #8 x 2 ¹₂ " deck screws
¹₈ " Dia. for #14 x 1 ¹₄ " pan head screws
¹₄ " Dia. for ³₈ " x 3" lag screws
88" to the
ground
1³|₄"
4"
x 4
"
Shown without roof for easier viewing.
Counterbore and drill
from this side.
For Bronze 8' Tower
measure down 8"