Instructions / Assembly

73
SLIDE – Mounting Instructions
1"
18"
1"
1
. Align slide at right angle (90˚) to 48" play deck. Lip of slide should
rest on the play deck 1¹₂". Using the slide as a template, mark
play deck through the three holes in the slide. Drill three ¹/₈" holes
at marked location.
2. Attach slide temporarily to play deck with three #14 x 1¹/₄" pan
head screws provided.
3. Prepare level area where slide touches ground that is 1" below
surrounding grade.
4. Locate and mark the ground on the back side, on either side of
the star. Remove slide and screw Playset Anchor into the ground
(a long screwdriver will help). Screw the anchor deep enough so
that the loop at the top of the anchor will be flat against the back
surface of slide when the slide is in the final position.
5. Reinstall slide permanently, attaching it to play deck using
#14 x 1¹/₄" pan head screws provided.
6. Use the Playset Anchor as a drill guide and drill a ³₈" hole
completely through the slide. Attach slide to anchor with
one ³₈" x 1" hex bolt, two ³₈" washers and one ³₈" lock nut
provided in the anchor kit.
7. Fill in around bottom of slide to make surface level to
surrounding grade.
Caution: Failure to anchor the Slide properly could cause serious injury from children lifting the slide.
Caution: Do not install this slide over concrete, asphalt, packed earth, or any other hard surface. A fall
onto a hard surface can result in serious injury to the equipment user.
1
¹
₂"
Scoop Slide - PS 8813, Scoop Wave Slide - PS 8814 or
Giant Scoop Wave Slide - PS 8816
Climbing Bar Attachment
Attach Climbing Bars at dimen-
sions shown. Use the Climbing
Bar as a drill guide and drill ¹⁄₈"
holes 1" deep in the boards.
Attach with #14 x 1¹⁄₄" pan head
screws.
Items for CLIMBING BAR
(4) Climbing Bars
(16) #14 x 1¹⁄₄" pan head screws
IMPORTANT: The Climbing
Bars must be positioned as
specified, otherwise a head
entrapment could exist.
13³⁄₄”
12”
12”
12”
Gold Option
15¹⁄₄”
12”
12”
12”
Silver & Bronze Option