Instructions / Assembly

75
CLIMBING WALL – Assembly Instructions
1. Align top of Climbing Wall at right angle 90˚). Lip of
climbing wall should rest on the play deck 1¹₂". Using
the Climbing Wall as a template, mark play deck
through the three holes in the climbing wall. Drill three
¹
⁄₈" holes at marked locations. (Fig. 1)
2. Attach Climbing Wall temporarily to play deck with
three #14 x 1¹⁄₄" pan head screws provided.
3. Prepare level area where Climbing Wall touches
ground.
4. Locate and mark the ground on the back side and in
center of Climbing Wall. Remove Climbing Wall and
screw Playset Anchor into the ground (a long
screwdriver will help). Screw the anchor deep enough
so that the center of the loop at the top of the anchor
will be approximately 3¹₂" off ground when wall is in
the final position.
5. Reinstall Climbing Wall permanently, attaching it to
play deck using #14 x 1¹₄" pan head screws provided.
6. Use the anchor as a drill guide and drill a ³₈" hole
c
ompletely through the Climbing Wall. Attach Climbing
Wall to anchor with one ³₈" x 1¹₄" hex bolt, two ³₈"
washers and one ³₈" lock nut provided in the anchor
kit. (Fig. 2)
Warning
: Failure to anchor the Climbing Wall properly
could cause serious injury from children
lifting the Unit.
1¹|₂"
3¹|₂"
anchor location
Fig. 1
Fig. 2