Instructions / Assembly

77
1. Hook uncoated ends of chain onto Commercial Grade
Swing Hangers using Quick-Link Connectors included
with PS 7576 (purchased separately). Tighten securely
w
ith an adjustable wrench.
2
.
U
sing Quick-Link Connectors,
a
ttach the
Trapeze Bar and a one-link chain onto
coated
ends of Gym Ring chains .
NOTE: The one-link chain must hang under
the Trapeze Bar. Tighten securely with an
adjustable wrench.
3. Using Quick-Link Connectors, attach
Gym Rings to a one-link chain . Tighten
securely with an adjustable wrench.
4. Customize the height of your Gym
Ring/Trapeze Bar Combo, anywhere in
the Adjustment Zone, to fit your
child.
Warning: Failure to Tighten Quick-Link
Connectors securely could
result in injury.
A
djustment
Z
one
DISCOVERY TELESCOPE
1. Determine desired location for
pivot.
2. Drill a ¹⁄₈" diameter hole 1" deep.
3. Fasten pivot with #8 x 2¹⁄₂" deck
screw provided.
4. Snap Discovery Telescope onto
pivot.
COMMERCIAL GRADE TRAPEZE BAR
VERTICAL CLIMBER – Assembly Instructions
1. Position Vertical Climber so that the top is flush with
the top of the deck and mark pilot holes.
2. Drill ¹₈"holes 1" deep into the board.
3. Attach with five #14 x 1¹₄" pan head screws
(provided) on each side.
1. Position Vertical Climber so that the top is 15" below
the 60" deck, (flush with the top of the board attached
on Page 22, the Gold Back Tower Instruction or Page
41, the Silver Back Tower Instructions).
2. Drill ¹₈"holes 1" deep
into the board.
3. Attach with five
#14 x 1¹₄" pan head
screws (provided) on
each side.
Warning
Gap between Vertical
Climber and playset
must not exceed 3 ¹₂ "
or a head entrapment
may exist.
Warning
Gap must be greater
than 9" or a head
entrapment may exist.
BRONZE OPTIONGOLD & SILVER OPTION