Instructions / Assembly

6
Attach 60° half to the exit top using
⁵₁₆" x ³₄" hex bolts, ⁵₁₆" washers and
⁵₁₆" lock nuts as shown.
Finger tighten only at this time.
Attach one 60º Tunnel Assembly
to the Entrance Assembly using
⁵₁₆" x ³₄" hex bolts, ⁵₁₆" washers
and ⁵₁₆" lock nuts as shown.
Finger tighten only at this time.
Note: The long flange on the
60º Tunnel Assembly will
be rotated clockwise,
with three bolts between
the two long flanges.
Long Flange
Circular
Flange
Items for STEP 6:
(1) 60° half
(1) Exit Top
(7) ⁵₁₆" x ³₄" hex bolts
(
14) ⁵₁₆" washers
(7) ⁵₁₆" lock nuts
Items for STEP 7:
(1) Entrance Assembly
(1) 60º Tunnel Assembly
(14) ⁵₁₆" x ³₄" hex bolts
(28) ⁵₁₆" washers
(14) ⁵₁₆" lock nuts
Note: If the circular flanges along the Entrance Assembly are not straight due to packaging or shipping,
place components in direct sun and or use a household hair dryer to soften flanges. Then bend
straight using your hands.
Assembly Tip: If lining up holes is difficult, loosen bolts on the long flange of each component to give
more clearance.
60º Exit Assembly