Instructions / Assembly

ManualsBrandsPlayStar ManualsOtherWater Slide Kit

Assembly Instructions

PS 8840-2

Call Toll Free 1-888-752-9782

Customer Service: Monday - Friday, 8:00 A.M. to 5:00 P.M. C.S.T.

We’re Here To Help!

Splash Action

Important!

Important! Intended for residential use by children ages 2 to 10,

only on properly installed PlayStar playsets. Before use refer to

complete safety guidelines in your original playset,

at www.playstarinc.com

, or at 1-888-752-9782.

Summary of content (4 pages)

PAGE 1
Splash Action® Assembly Instructions Important! Important! Intended for residential use by children ages 2 to 10, only on properly installed PlayStar playsets. Before use refer to complete safety guidelines in your original playset, at www.playstarinc.com, or at 1-888-752-9782. We’re Here To Help! Call Toll Free 1-888-752-9782 Customer Service: Monday - Friday, 8:00 A.M. to 5:00 P. M. C.S.T.
PAGE 2
CONTENTS Water Slide Kit Contains: (1) Water Slide (2 pieces) (1) Water Cannon (4) Water Slide Stakes TOOLS REQUIRED All Mounting Hardware Complete Illustrated Instructions Drill ¹⁄₈" & ¹⁄₄" Drill Bits Saw Tape Measure Screwdriver (regular or phillips) Hammer Shovel Adjustable Wrench ⁷⁄₁₆" Wrench ⁹⁄₁₆" Wrench HARDWARE INCLUDED (shown actual size) ¹|₄" x 2" machine screw (2) ³|₈" lock nuts (10) ¹|₄" lock nuts (6) ⁵|₈" rubber washers (2) ³|₈" x ³|₄" hex bolts (10) ³|₈" washers (20) ¹|₄" washers (6) F
PAGE 3
TEMPORARY INSTALLATION For temporary installation of the Water Slide, use the Water Slide Stakes. Fig. 1 Water Slide Note: Temporary installations are not recommended over sand or loose soil. 4" 4" 1. Prepare a level area where the water slide is to be installed. WARNING: Do not install the water slide within six feet of any structure or obstruction. 2. Align the Splash Action Water Slide entrance to the exit of the beginning slide.
PAGE 4
5. Cut four 18" pointed stakes from the 2"x4"x8' board. Drive the four wooden stakes into the ground at 30° angles as shown in each marked location so they are flush with the prepared surface. (Fig. 2). Note: If soil conditions permit stakes to be pulled out easily, such as in sandy soil conditions, cementing is required. If your ground is too hard to pound In the stakes, you can remove the earth with a shovel. Install the stakes and compact the earth as you replace it.