Use Instructions

5
• Do not expose the batteries to any extreme
conditions (e.g. radiators or direct sunlight).
Otherwise there is an increased risk of
leakage.
• Warning. This item contains a button cell
battery. A button cell battery can cause serious
internal chemical burns if swallowed.
• Warning. Dispose of used batteries
immediately. Keep new and used batteries
away from children. If you suspect that
batteries have been swallowed, or inserted
into any part of the body, consult a physician
immediately.
• The power supply used with the electric toy
should be inspected regularly for damage to
the power cord, plug, housing or other parts
and, if damaged, should not be used until the
damage is repaired.
Danger!
• Handle damaged or leaking batteries with
extreme caution and dispose of them properly
as soon as possible. Wear gloves when doing
so.
• If you come into contact with battery acid,
wash the affected area with water and soap.
If battery acid gets in your eye, rinse it with
water and seek medical attention immediately!
• The connection terminals must not be short-
circuited.
Replacing the battery (Fig. B)
WARNING! Observe the following
instructions to avoid mechanical and
electrical damage.
There is a battery in the product.
You can replace the battery (2e) when it is not
working anymore.
1. To open the battery compartment (2a),
press into the hole (2c) on the bottom of the
remote control (2) using a suitable object (not
included).
Note: Pressing pushes the battery compartment
out of the remote control a little.
2. Pull the battery compartment out of the remote
control.
3. Remove the old battery (2e) and insert a new
battery (not included in the package contents)
carefully into the battery compartment. The
battery must be inserted into the battery
compartment completely.
Note: Check the plus/minus poles of the
battery, and insert it correctly.
4. Insert the battery compartment into the remote
control until it is completely inside the remote
control.
Use
Remove the safety film (2b) from the battery
compartment (2a) before using the remote
control (2) (Fig. B).
Turning on the product
1. Plug the USB connector (1b) of the USB
cable (1a) into a USB port on a powered-on
computer or charging station with a USB port
(Fig. A).
2. Press the button (2f) on the remote control (2)
to turn the product (1) on (Fig. C).
Turning off the product
1. Press the button (2f) on the remote control (2)
to turn the product off.
2. Unplug the USB connector (1b) of the USB
cable (1a) from the USB port on a powered-
on computer or charging station with a USB
port (Fig. A).
Remote control (Fig. C)
The remote control has the following buttons:
• MODE +/- (2f): Press the buttons to change
the different light modes in demo mode.
• SPEED +/- (2g): Press the buttons to change
the speed of the light mode in demo mode.
• BRIGHT +/- (2h): Press the buttons to
change the brightness of the product.
• COLOR +/- (2i): Press the buttons to get
a different color.
• Color buttons (2j): Press the desired color
button White, Red, Green, Blue, Yellow,
Turquoise or Violet.
• DEMO (2k): Press the button to see
a demonstration of the different light modes.
US-EN