Installation Guide

Main Power Button:

This button supplies power to all the functions of the

replace.ThemainpowerbuttonmustbeintheON position,

either from the remote or on the touch pad for the functions

to work.

Timer Button:

This button controls the timer ON/OFF and 10-time setting

from30minutesto9hours.WhentheTimerisrstturned

on, it will come on at the shortest time setting (30 minutes).

Each time the Timer button is pressed, the time increases 1

hour, up to the longest setting (9 hours). Once the set time

expires,allreplacefunctionswillbeautomaticallyturnedoff.

Flame Control button:

Thisbuttoncontrolsthebrightnessoftheameeffectwith

settingsatHigh,MediumandLow.Whenthereplaceisrst

turnedon,theamewillcomeonatthehighestsetting.The

replacewillrememberthelastamesettingusedandin

laterusetheamebrightnesswillstartatthatsetting,unless

power to the unit has been interrupted. Each time the Flame

buttonispressed,theamebrightnessdecreases.Theonly

waytoturnofftheameeffectcompletelyistoturnoffthe

Main Power button.

Heater Control Button:

This button controls the heater ON/OFF and 11 temperature

modes from 68°F (20°C) to 88°F (31°C). When the heater is

rstturnedon,itwillcomeonatthelowestroomtemperature

setting 68°F (20°C). Each time the Heater Control button

is pressed, the temperature set point increases 2°F (1°C),

allowing you to adjust the ambient temperature, up to 88°F

(31°C).Thereplacewillrememberthelastheatsetting,and

in later use, the heater will start at that setting, unless power

to the unit has been interrupted.

Note: To switch between Fahrenheit/Celsius modes see

control panel Fahrenheit/Celsius display instructions.

OPERATING INSTRUCTION

Figure 5