Installation Guide

CARE AND MAINTENANCE

GlassInformation:

Maintenance of Motors:

Cleaning:

Before attempting ANY maintenance:

1. Turn off power to the unit.

2. Unplug the power cord from outlet.

3. Letreplacecoolifithasbeenoperating.

1. Under no circumstances should this product be operated with broken glass.

2. Do not strike or slam the glass.

3. Do not use abrasive cleaners to clean the glass.

4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer

 shouldbedonebyaqualiedserviceperson.

Always disconnect the appliance from the main power supply and allow it to cool before any

servicing operation.

Themotorsusedonthefanheaterandameblowerarepre-lubricatedforextendedbearinglifeand

require no further lubrication. However, periodic cleaning/vacuuming of the appliance around the air

intake and exhaust, as well as the fan heater is recommended. For heavy or continuous use, periodic

cleaning must be done more frequently. If the heater blows alternating cold and warm air, check the

fanforfreemovementandfordebrisrestrictingairow.Ifthefandoesnotmovefreely,theunitmust

be turned off and the fan replaced immediately in order to prevent further damage to the unit.

Cleaningofthecontrolpanel,locatedintheupperright-handcornerofthereplacebehindthe

sliding control panel cover, is to be done only using a soft cloth, slightly dampened in water

(if needed, a small amount of dish soap can be added to the water) and dried using a clean,

dry soft cloth. Cleaning of the screen diffuser is to be done using only water and a lint free cloth.

DO NOT use any abrasive household cleaners as these products will damage the touch-pad

controls and the diffusing screen.