Installation Guide

Mounting Brackets

INSTALLATION INSTRUCTIONS

1. Place the assembled mantel near a 15-amp, 120-volt grounded electric outlet.

Read all instructions before using this appliance.

2. Place the insert directly in front of the mantel opening.

3. Carefullylifttheinsertthroughthecenteropeninginthefrontofthereplace.Thebottomofthe

insert has two foam rubber strips to prevent scratching of the hearth base. Slide the insert back

through the opening until the metal trim makes contact with the front of the mantel.

4. Install the mounting brackets provided with the insert in the pre-drilled holes on the top of the

insert (see Figure 2).

5. Carefullypositionmantelwithinstalledreplaceagainstwall.

6. Plug the power cord into the 15-amp, 120-volt outlet. Use an extension cord rated for a minimum

of 1,875 watts if necessary.

Figure 2

CAUTION: Make sure that the unit is installed so that the power cord is not

compressed against or caught on the unit or the mantel and that it has an

unobstructed path to the grounded outlet.

Infrared Remote Control