Full Product Manual

6
INSTALLATION INSTRUCTIONS
Carefully remove all contents from the carton
and place the Fireplace Glass Door on a at,
padded surface to avoid damaging the nish.
Always lift the door by the sides, not the top
frame. Check the included hardware against
the parts list.
If you are missing parts, please call GHP
customer service at 1-877-447-4768.
CAUTION: Before installing the Glass
Door, make sure the replace is cool.
STOP! Please refer to our installation video at:
https://www.youtube.com/watch?v=reR-LUvl62g
1. Mount door handles (L) to the glass doors
(left and right hand door assemblies) using
the screws provided with the handles.
2. This step may NOT be necessary!
The frame height (shown on Page 2) includes
a 2” riser bar. If your replace opening height
matches the dimensions noted below, DO NOT
ATTACH THE RISER BAR:
If the riser bar is required, lay the door face
down on a at, padded surface. Attach the riser
bar with two (2) 8-32 x 5/8” Machine Screws
(F) and two (2) Hex Nuts (G) as shown in
Figure 2. Use caution to protect your hands
from possible sharp metal edges. The back
edges of the riser bar and the back edges of
the bottom frame should be ush. In some
cases, the riser bar will extend in front of the
assembly frame which is correct.
NOTE: If your frame does not require a riser
bar, the screws (F) and nuts (G) may be
discarded.
1
2
Size Opening height
Small 27 3/4” or less
Medium 30 3/4” or less
Large 30 3/4” or less