Installation Guide

4
Carefully remove all contents from the carton
and place Fireplace Glass Door on a at,
padded surface to avoid damaging the nish.
Always lift the door by the sides, not the top
frame. Check hardware against the parts list.
If you are missing parts, please call GHP
customer service at 1-877-447-4768.
CAUTION: Before installing the Glass
Door, make sure the replace is cool.
1. Mount door handles (L) to glass doors (left
and right hand door assemblies) using the
screws provided with the handles.
2. NOTE: This step may not be necessary!
The actual frame height (shown on Page 2)
includes a 2” riser bar. If your replace opening
height matches the dimensions noted below,
DO NOT ATTACH THE RISER BAR:
Size Opening height
Small 27 3/4” or less
Medium 30 3/4” or less
Large 30 3/4” or less
When the riser bar is required, lay the door
face down on a at, padded surface. Attach
the riser bar with two (2) 8-32 x 5/8”
Machine Screws (F) and two (2) Hex Nuts (G)
as shown in Figure 2. Use caution to protect
your hands from possible sharp metal edges.
The back edges of the riser bar and the back
edges of the bottom frame should be ush. In
some cases, the riser bar will extend in front
of the assembly frame which is correct.
NOTE: If your frame does not require a riser
bar, the screws (F) and nuts (G) may be
discarded.
INSTALLATION INSTRUCTIONS
1
L
2
F
G