Use and Care Guide
9
OPERATING INSTRUCTIONS
2
3
1
The remote control (B) relies on a line of sight and must
be pointed at the controls of the log set to work. The
remote control (B) has the controls required to turn ON/
OFF both the main power and the heater. If you prefer to
use the control buttons on the log set unit itself, they are
on the lower right corner of the unit.
1. Plug your log set into a 15-amp, 120-volt power outlet.
2. Turn the power on. Flame will show on the wall behind
the log set.
3. Remove plastic tab from inside battery compartment
to activate remote control (B).
4. Point the remote control (B) directly at the control but-
tons of the log set and use the buttons to operate the
log set.
Main Power Button:
This button supplies power to all the functions of the log set.
The main power button must be in the ON position, either
from the remote or the controls on the log set for the func-
tions to work.
Heater Control Button:
This button controls the heater ON/OFF and 5 temperature
on, the heater will come on at the lowest room temperature
setting. The log set will remember the last heat setting and
in later use the heater will start at that setting, unless power
to the unit has been interrupted. Each time the temperature
button is pressed, the temperature set point increases,
allowing you to adjust the ambient temperature.
Flame Control button:
power to the unit has been interrupted. Each time the Flame
main power button.
The plastic tab inside the battery
compartment MUST be removed
before remote control (B) will operate.
1
2
3
(Pull tab)
Remote Control: