Instructions / Assembly

13
10-1
9. Burner Assembly Installation
9-1. Line up holes in the burner assembly (B) with
corresponding holes in the table assembly.
Insert four M5X12 screws (EE) through holes.
Fasten them. The control knob should face the
front side of the unit, the same as the door.
Hardware Used
9-2. The assembled unit will look like the gure 9-2.
10-1. Screw the knob (O) on the table lid (A) with
M4 X 5 screw (AA). Pour glass rocks (one pack)
(P) above the burner and put the table lid above
the burner assembly. Do not cover ignition screen
with glass rocks.
Hardware Used
9-2
9-1
ASSEMBLY INSTRUCTIONS
EE
Screw M5 X 12 X 4
AA
Screw M4 X 5 X 1
FF
Phillips screwdriver
X 1
FF
Phillips screwdriver X 1
O
O
AA
A
P
EE
B
Caution: Never place a table lid on the
re pit when in use. Ensure the re pit
has cooled before placing a table lid over
the re pit.