Use and Care Manual
11
ASSEMBLY INSTRUCTIONS
1. Attach the bottom plate (J) to the left and right side
panels (F and M) with four M6X12 bolts (AA) as
shown on gure 1. Make sure the center ring on the
bottom plate (J) is positioned closer to the
magnet side of left side panel (F). Tighten with
Phillips screwdriver (EE). The conguration as
pictured is upside down. Keep the unit in this
position.
Hardware Used
2. Screw the four feet (N) into the bottom of the left and
right side panels (F and M) as shown on gure 2.
3. Turn the unit upright. Attach the back panel (L) to
the left and right side panels (F, M) with four M6X12
bolts (AA) as shown on gure 3. Tighten with Phillips
screwdriver (EE).
Hardware Used
1
2
3
AA
AA
Bolt M6 X 12
Bolt M6 X 12
X 4
X 4
J
M
N
F
M
M
L
F
F
EE
Phillips screwdriver
AA
AA
AA
Magnet
EE
Phillips screwdriver