Installation and Owner's Manual

REMOTE CONTROL OPERATION

TRANSMITTER WALL CLIP

The transmitter can be hung on a wall using the clip provided. If the clip is

installed on a solid wood wall, drill 1/8" pilot holes and install with the screws

provided. If it is installed on a plaster/wallboard wall, first drill two 1/4" holes into

the wall. Then use a hammer to tap in the two plastic wall anchors flush with the

wall; then install the screws provided.

BATTERY LIFE

Replace all batteries regularly. When the transmitter no longer operates the remote receiver from a distance it did previously (i.e., the

transmitter's range has decreased) or the remote receiver does not function at all, the batteries should be checked. It is important that

the remote receiver batteries are fully charged, providing combined output voltage of at least 5.5volts. The hand held transmitter should

operate with as little as 2.5 volts battery power.

TROUBLE SHOOTING

If you encounter problems with your fireplace system, the problem may be the fireplace itself or it could be with the CON1001-TH

remote system. Review the fireplace manufacturer's operation manual to make sure all connections are properly made. Then check

the operation of the remote in the following manner:

• Make sure the batteries are correctly installed in the RECEIVER. One reversed battery will keep receiver from operating properly.

• Check battery in TRANSMITTER to ensure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for tighter fit.

• Be sure RECEIVER and TRANSMITTER is within 20-feet operating range.

• Clear Codes: Memory in the receiver might be full if the learn button is pressed too many times. If this happens it will not allow any

more codes to be learned and no audible beep will be heard. To clear memory, place the receiver slide switch into the REMOTE

position. Press the learn button and release after 10 seconds. You should hear three (3) long audible beeps indicating all codes

have cleared. You can now “learn” the transmitter to the receiver as described in the General Information Section.

• Keep RECEIVER from temperatures exceeding 130° F. Battery life shortened when ambient temperatures are above 115° F.

• If RECEIVER is installed in tightly enclosed metal surround, the operating distance will be shortened.

• Rechargeable batteries should not be used. They do not supply sufficient power to operate the remote system.

SPECIFICATIONS

BATTERIES: Transmitter (2) 1.5 volt AAA t bateries

Remote Receiver 6V - 4 ea. AA 1.5 Alkaline

FCC ID No.'s: transmitter - K9LSP1001TH; receiver - K9L330IRX

Operating Frequency: 303.8 MHZ Canadian IC ID No.'s: transmitter – 2439A-SP1001TH; receiver – 2439A-3301RX

FCC REQUIREMENTS

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY

UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S

AUTHORITY TO OPERATE THE EQUIPMENT.

WALL CLIP

SLOT

WALL CLIP

BATTERY

COMPARTMENT